 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 800W Parallel (N+1) With PFC Function Features : AC input 180~260VAC only PF> 0.98@ 230VAC SCP-800 series Protections: Short circuit / Overload / Over voltage / Over temperature Built in remote sense function Built-in remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan 3 years warranty SPECIFICATION ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT(max.) OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE Note.4 SCP-800-09 800S-P009 9V 88A 0 ~ 88A 792W SCP-800-12 800S-P012 12V 66A 0 ~ 66A 792W 120mVp-p SCP-800-15 800S-P015 15V 53A 0 ~ 53A 795W 150mVp-p SCP-800-18 800S-P018 18V 44.4A 0 ~ 44.4A 799W 180mVp-p SCP-800-24 800S-P024 24V 33A 0 ~ 33A 792W 240mVp-p SCP-800-36 800S-P036 36V 22.2A 0 ~ 22.2A 799W 360mVp-p SCP-800-48 800S-P048 48V 16A 0 ~ 16A 768W 480mVp-p SCP-800-60 800S-P060 60V 13A 0 ~ 13A 780W 500mVp-p 1.0% 0.5% 0.5% RIPPLE & NOISE (max.) Note.2 90mVp-p 3.0% Typical adjustment by potentiometer VOLTAGE TOLERANCE Note.3 1.5% 1.0% 1.0% 0.5% 1.0% 180 ~ 260VAC 47 ~ 63Hz >0.98 / 230VAC 83% 5.0A / 230VAC 60A / 230VAC 3.5mA / 240VAC 105~115% rated output power 84% 85% 0.5% 0.5% 0.5% 0.5% 20% ~ 100% adjustment by 1 ~ 5VDC external control 1.0% 1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 800ms, 400ms, 12ms at full load 260 ~ 370VDC see the derating curve 86% 88% 88% 89% 90% Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC / 70% RH SAFETY & I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC / 25 ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A (Note. 5) Compliance to EN61000-3-2,3 HARMONIC CURRENT EMS IMMUNITY POWER GOOD SIGNAL SPECIAL FUNCTION OTHERS COOLING MTBF DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A Open collector of NPN transistor DC Voltage Adj., remote sensing, remote control, parallel operation(refer to control terminal instruction manual) By fan, >20% load or >50 fan on ) 74.9K hrs min. MIL-HDBK-217F(25 290*120*68mm (L*W*H) 1.9kg; 8pcs / 22kg / CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: SCP-800-SPEC 2008-05-06 800W Parallel (N+1) With PFC Function Mechanical Specification SCP-800 series Unit:mm 18.5 9.2 11 41 10 190 10 39 30 CN1 38 68 1 23 #6-32-4 M3(NUT)X3H-4 12345678 LED Vadj NEG- 15 POS+ 120 9 251 30 M3(NUT) 3H-4 AIR FLOW DC OUTPUT AC INPUT POS M6 NEG 26.5 17 Terminal Pin No. Assignment Pin No. 1 2 3 Assignment AC/L AC/N FG Control terminal Pin No. Assignment (CN1) : Dinkle 51HDBC-O8P or equivalent Pin No. 1 2 3 4 Assignment VS+ VSVCI VCO Pin No. 5 6 7 8 Assignment Mating With PG PAR Dinkle 51SDB-O8P or equivalent GND INH Derating Curve Ta=25 100 800 700 80 OUTPUT POWER (W) 600 550 400 450 300 LOAD (%) 60 40 20 -20 -10 10 20 30 40 50 60 70 90 110 150 89 170 BOTTOM SIDE 14 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: SCP-800-SPEC 2008-05-06 800W Parallel (N+1) With PFC Function Control terminal instruction manual SCP-800 series LOAD LOAD LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH ON/OFF SWITCH VS+ VSVCI VCO PG PAR GND INH H:ON L:OFF USING INTERNAL VOLTAGE CONTROL REMOTE SENSING ON/OFF CONTROL BY SWITCH ON/OFF CONTROL BY TRANSISTOR Vout GOOD FAIL : LED OFF : LED ON O.V.P. 120% (Typ.) 120 100 LOAD LOAD OUTPUT VOLTAGE (%) 80 60 40 20 Non-Linear VS+ VSVCI VCO PG PAR GND INH 40V / 0.5A MAX. VS+ VSVCI VCO PG PAR GND INH DC 1-5V POWER GOOD SIGNAL OUTPUT VOLTAGE ADJUST WITH DC 1-5V 1 2 3 4 5 6 V EXTERNAL VOLTAGE (DC) LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH PARALLEL OPERATION WITH REMOTE SENSING PARALLEL OPERATION WITHOUT REMOTE SENSING File Name: SCP-800-SPEC 2008-05-06 |
Price & Availability of 800S-P012
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |